Starship Modeler Discussion Forums

Well turns out the board isn't fried just burned out the leds on the bottom of the secondary hull. Big relief but still trying to find the short. All I can figure is that my foil tape grounded out a circuit like mr. engineer was saying. Gonna replace the two burned bulbs and go at it again. Wish me ...

I'm building a PL E. and have purchased the trekmodeler DIY light kit. well any way last night i was attaching the two have of the engineering and tested my lights and some how managed as far as I can tell fried my strobe and nav light board. has any one else had this happen? i'm kinda stressin this...

Well had to scrape and scrub that crap off what a pain thanks for the advice guys:-)

Do you guys think I should let it sit for a few days? Think it may cure over extended period?

No its not old I just used it on something else and it worked great. Just used a hair dryer and heated it up I think I'll give some time before I have to tear it apart. And when I heated it it seemed to discolor has anyone experienced this?

Used some delvcon 5min. epoxy on my build last night and the stuff still hasn't set up. What should I do? Do I have to take it all apart and clean it ?