The "Corrugated" effect

erospawn · Post by **erospawn** » Mon Jun 01, 2009 7:24 pm

Does anyone have any tricks when creating a surface that has a lot of straightlines? Trying to etch them in is rediculous.. What I mean by that is if you look at the side of the warp nacelles, where the blue light is, for say example, the Enterprise E

.. you see straight lines in the clear parts..

Squall67584 · Post by **Squall67584** » Mon Jun 01, 2009 11:55 pm

I know Plastruct sells plastic sheets in a multitude of different sized corrugated patterns, but I'm not sure if any of them are clear...

illithid00 · Post by **illithid00** » Tue Jun 02, 2009 12:30 am

You could always build a master and vacform clear plastic sheet over it.

Kylwell · Post by **Kylwell** » Tue Jun 02, 2009 12:25 pm

Evergreen also has scribed sheets.