Instruction sheet needed

Concorde · Post by **Concorde** » Wed Nov 18, 2009 6:12 pm

ok, I've obtained this model kit: http://www.frontiermodels.co.uk/USS-ENT ... 17999.html from a small store in my town.

the kit is in great condition. all the parts are in their original packaging, the decals are in great condition. but there's no instruction sheet.

would it be possible for someone who h...as the instruction sheet of this kit to copy it and send it to me via RL mail or email?

thank you

I REALLY need this instruction sheet!

Joseph C. Brown · Post by **Joseph C. Brown** » Wed Nov 18, 2009 9:52 pm

Have you seen this site? Lots of tips for any Movie-Era Enterprise:

http://www.paveglio.com/startrek/index.html

If that doesn't help, I'll see about scanning in my old instruction sheets on this kit.

Concorde · Post by **Concorde** » Wed Nov 18, 2009 10:16 pm

that looks very interesting, thank you. but that's wayyy too advanced for me. I can't do aztecing to save my life. I can do small details like on the warp nacelle pylons, the fore secondary hull at the base of the neck. and the sensors along the edge of the Primary Hull.

and thank you for taking the time to copy the instruction sheet

also, I'll need some advice on what colors to use. and what parts to use them on

Joseph C. Brown · Post by **Joseph C. Brown** » Thu Nov 19, 2009 7:58 am

I just found the correct instructions, and will get them scanned in just a few minutes. Now, my advice for painting? Go over to the Trek part of the forum, and start a thread titled something like: 'Painting advice for Ent-A requested' and you'll get *tons* of better advice than I can give!