Small Circuit for Blinking LEDs?

Ask and answer questions, share tips and resources for installing lighting and other electronics in your models.

Moderators: Sparky, Moderators

Post Reply
User avatar
Tchail
Posts: 4331
Joined: Tue Mar 04, 2003 8:40 pm
Location: Nowhere in Particular

Small Circuit for Blinking LEDs?

Post by Tchail »

I know that you can buy flashing LEDs.

And I've also built a couple of kits that allow you to create flashing LEDs.

But does anyone know what is the smallest circuit out there that can flash a 3v surface-mount LED?

I ask this because I got my hands on several "body lights" from Thatscoolwire.com.

http://www.thatscoolwire.com/store/subc ... goryID=165

These include several surface-mount LEDs that apparently flash in a random pattern.

Any advice would be greatly appreciated.

-Tchail
“In the beginning the universe was created. This made a lot of people angry, and has generally been regarded as a bad move." Episode 5, The Hitchhiker's Guide to the Galaxy
User avatar
tetsujin
Posts: 2353
Joined: Mon Feb 28, 2005 6:08 pm
Contact:

Post by tetsujin »

Probably the smallest circuit you can get to flash an LED is a "blinking LED". Blinking LEDs have the flasher circuit built-in. A blinking LED doesn't pass current when it's "off", so you should be able to wire a second LED in series and make them both blink (if the first blinking LED doesn't produce the color you want or something...)

A blinker circuit can be very simple - but to make it yourself, and make it small, may be more work than it's worth. You could use something like an "Arduino Pro Mini" (18mm x 33mm) or "Teensy" (18mm x 31mm) - program it to blink one LED or a dozen however you want... A microcontroller is definitely overkill for a job like blinking a LED, but in a way it's sometimes not worth going with anything less. And microcontroller solutions can be very small, since you don't really need more than the IC and a board to put it on. I have a microcontroller board that I designed for myself that's around 1cm square (the smallest is around 9mm x 10mm) - I can fit one of those almost anywhere.
---GEC (三面図流の初段)
There are no rats.
The skulls eat them.
User avatar
opal_1970
Posts: 57
Joined: Mon Oct 31, 2011 4:17 pm

Post by opal_1970 »

If you are going to use an Arduino, you can export your code to an ATtiny85 microcontroller for example, and then just hook up your power/GND and LEDs to one or all of its 5 Output pins and you are good to go, and you do not need to put the much larger arduino in your build. Each output can support a separate blink pattern, the number of LEDs that you can hook up to each pin is dependent on how much power you are running. The ATtiny85 is about the size of your fingertip, perhaps somewhat smaller. There are other chips that are bigger if you need more than 5 outputs, but the 85 is the smallest that I am aware of.

check out this site for an excellent how-to...

http://blog.makezine.com/2011/10/10/how ... -projects/
-------------------------------------------
"I honor those who have gone where I have yet to go, who have seen what I have yet to see; for they are the true pioneers. May your journey be an adventure." -- Nomad farewell to the dead


Current build: TOS Galactica (Take 2)
Post Reply