I've recently become enamored of the superglue & talc putty method. I've come to a point where I'm using it as a bondo/mori-mori alternative for gross recontouring (works faboo, and dirt cheap too).
Is there any substance I can use as a barrier/release coating to selectively prevent the CA from adhering to something? Say if I wanted to make a surface on one part that would be form fitted, but not attached, to the surface of another?
Barrier/release coatings for SGT application?
Moderators: DasPhule, Moderators
-
Shinnentai
- Posts: 3159
- Joined: Fri Jul 12, 2002 5:32 pm
- Location: Fuschal; the promised land.
Barrier/release coatings for SGT application?
"Chaos is found in greatest abundance wherever order is being sought. It always defeats order, because it is better organized."
-Ly Tin Wheedle
-Ly Tin Wheedle
Paul Boyer from FSM did something similar. He used milliput, but what he did was to cover the main part with BareMetal foil. Built up the new part (IIRC, it was a new nose for an MH-53) and then could pop it off. It would probably be a good idea to warm the area a bit first, and not wait too long after attaching it.
Kev
Kev