Wiring cold cathodes

Ask and answer questions, share tips and resources for installing lighting and other electronics in your models.

Moderators: Sparky, Moderators

Post Reply
compucrap
Posts: 1090
Joined: Fri Jul 12, 2002 2:58 pm
Contact:

Wiring cold cathodes

Post by compucrap »

Hey,

So say I had 2 liquid cold cathode light tubes, and I wanted to wire them together so they could both run off one DC 12v? I'd like to get some simulated warp drive action going on with them.

Josh
-Josh A
Sparky
Moderator
Posts: 2404
Joined: Thu Jun 05, 2003 8:28 am
Location: Are we there yet? (Chicago)
Contact:

Post by Sparky »

Be careful with the insulation on these wires. Was handling the inverter and touched my finger tip across the output terminals. It was shocking and smelt of burnt finger.

I tested an inverter with two short tubes that I got from kitsusa, and it ran the two 4 inch tubes in series. I believe the driver was meant for the 12 inch tube, though it is the only one they sell. Whether this can be done with a given set of tubes and inverter has to do with the startup voltage and the running current requirements of the tubes.
<a href="http://www.kc6sye.com/2_wheresaneatpart.jpg" target="_Sparky">Is this plastic thingy on the counter a neat part?</a> <a href="http://www.kc6sye.com/1_casting_inprogress.jpg" target="_Sparky">Let's cast it.</a>
User avatar
Kitkat
Posts: 405
Joined: Mon Jul 15, 2002 10:59 am
Location: Orlando, FL

Post by Kitkat »

Yeah, as long as they're 4" or 6" for that matter, you can run them off one inverter...you have to run them in an series circuit though.
User avatar
Marco Scheloske
Posts: 5251
Joined: Sun Jul 14, 2002 11:08 am
Location: Moenchengladbach, Germany

Post by Marco Scheloske »

The cold cathodes I have here at home came with an inverter which can be used for either one or two cold cathodes (two plugs).
Greetings from Germany -
"In glue we trust!" - http://technomaniaweb.jimdo.com

Marco
Post Reply