Velleman MK107

starlifter · Post by **starlifter** » Fri Feb 26, 2010 8:19 pm

hey folks,

has anyone used the velleman mk-107 kit? I've successfully assembled one for my LED running lights and I'd like to hotwire it into the rest of my setup. the problem I can't figure out is how to bypass the off/on switch so that it's always 'on' when power is applied and also, how to make sure the program doesn't change so it stays on the original program, 8 leds flashing one at a time in sequence. thanks!

Scott Hasty · Post by **Scott Hasty** » Mon Mar 01, 2010 9:13 am

Pull the switch and solder a wire across the power switch pads on the PCB.