]Hey all, I figured quite a few people here have put this 1/350 Enterprise NCC-1701 Polar Lights model together with the lighting kit.
I seem to have run into a bit of a snag. I was so close to finishing this guy off today but both my Bussards aren't lighting up.
That being said, the motors that run through both of the PCBs in the Bussards are spinning. I am not sure what is going on. Here is a close up video of just connecting the K wire from the secondary hull PCB to the Bussard PCB to the motor:
https://www.dropbox.com/s/stnvj0vv2aok5 ... no_led.avi
Here is the ship with all the lights:
https://www.dropbox.com/s/zauiyqnck3d7w ... lights.avi
I was confused about wire K in the instructions, do I need to cut it at both ends? So I can connect it to wire J, just to connect it to the secondary hull PCB or can I just connect the K wire to the board directly? Doesn't seem like it would matter...
Arg and I just took a look at the instructions, on the site and they changed them a bit looks like both k wires connect to 1 J, will that help? My instructions show that the secondary hull PCB has 3 J inputs versus the one on the website shows 2...
http://www.round2models.com/files/instr ... mka007.pdf
Thanks,
Andrew
Aziz Light!