Bussard spinning circuit

Ask and answer questions, share tips and resources for installing lighting and other electronics in your models.

Moderators: Sparky, Moderators

Post Reply
belkin321
Posts: 104
Joined: Mon Aug 11, 2008 2:26 am
Location: Arizona

Bussard spinning circuit

Post by belkin321 »

Greetings,
I have a bussard circuit to make spinning leds. It spins in one direction...how do I build the other to spin the opposite direction? Are the leds wired to different pin outs or ?
belkin321
Posts: 104
Joined: Mon Aug 11, 2008 2:26 am
Location: Arizona

Bussard spinning circuit

Post by belkin321 »

No electronic wizards in the house?
belkin321
Posts: 104
Joined: Mon Aug 11, 2008 2:26 am
Location: Arizona

Dip

Post by belkin321 »

:dup
User avatar
Rondie
Posts: 281
Joined: Fri Aug 01, 2008 12:43 pm
Location: Hoorn, The Netherlands
Contact:

Post by Rondie »

What's the circuit? I assume you bought it somewhere, do you have a link to the layout? I'm sure it can be reversed, if only by inserting the LEDs on the other side of the board (if you understand me there).
Rondie

-Admiral Ackbar Cereal-
Your taste buds can't repel flavor of that magnitude!
belkin321
Posts: 104
Joined: Mon Aug 11, 2008 2:26 am
Location: Arizona

Bussard spinning circuit

Post by belkin321 »

The circuit uses a 4060 and 555 IC chip. The leds rotate clockwise. I am not that good with electronics. I want to make two led circuits that spin towards each other.
Redag
Posts: 124
Joined: Fri Jan 14, 2011 1:50 am
Location: Chicago, IL

Post by Redag »

As the other dude said, this is easy so long as you follow the logic, just re-order the LEDs in reverse. If you don't know how, you need to learn up or we really can't so much as tell you.
belkin321
Posts: 104
Joined: Mon Aug 11, 2008 2:26 am
Location: Arizona

Bussard spinning circuit

Post by belkin321 »

The circuit uses a 4060 and 555 IC chip. The leds rotate clockwise. I am not that good with electronics. I want to make two led circuits that spin towards each other.
mhvink
Posts: 95
Joined: Mon Jun 25, 2007 5:10 pm
Location: Fresno, CA

Post by mhvink »

Ok, we all assume that you have TWO round PC boards that the LED's solder into. If that is true, make ONE as normal. Then take the SECOND round board and flip it over so that the back is now the front. Install the LED's on the NEW front side. Wire the 2nd board to the rest of the circuit as per the instructions and now the 2nd board should spin in the opposite direction.
belkin321
Posts: 104
Joined: Mon Aug 11, 2008 2:26 am
Location: Arizona

Bussard spinning circuit

Post by belkin321 »

Thanks for all the replies
belkin321
Posts: 104
Joined: Mon Aug 11, 2008 2:26 am
Location: Arizona

Bussard spinning circuit

Post by belkin321 »

Thanks for all the replies
Post Reply