lighting Venator using Fiber-Optic
Moderators: Sparky, Moderators
-
Paul Stephens
- Posts: 154
- Joined: Sat Feb 02, 2008 2:07 pm
- Location: Birmingham AL
lighting Venator using Fiber-Optic
Are there any tutorials on lighting the Revell Venator. Step by step for using fiber optics.
"If your still alive it's because Jack Bauer hasnt killed you yet"
-
modelrealms
the basics,
step 1: find a place on the model you want light
step 2: drill hole
step 3: push fiber optic out of the hole from the inside 1/8" to 1/4"
step 4: repeat steps, 1,2 and 3 until all the light you want is finished
step 5: add light source to fiber optic
step 6: add power to light source
step 7: paint model
step 8: cut off eccess fiber optics
step 9: display model
step 1: find a place on the model you want light
step 2: drill hole
step 3: push fiber optic out of the hole from the inside 1/8" to 1/4"
step 4: repeat steps, 1,2 and 3 until all the light you want is finished
step 5: add light source to fiber optic
step 6: add power to light source
step 7: paint model
step 8: cut off eccess fiber optics
step 9: display model
-
Madman Lighting
- Posts: 1818
- Joined: Sat Mar 05, 2005 9:16 am
- Location: Serenity.
- Contact:
Check out my site: www.madmanlighting.com
Theres kits to buy, FAQs, connecting light sources to fibers, etc.
Heck, I'll even customise a kit for you if you want.
-John C.
Theres kits to buy, FAQs, connecting light sources to fibers, etc.
Heck, I'll even customise a kit for you if you want.
-John C.
That Madman Who Lit Up Deep Space Nine