Okay all.. I'm doing a project that's not really model related ...basically I'm converting my old Anakin AOTC FX Lightsaber (the very first one) from an EL to LED blade using the innards from the Anakin ROTS FX Lightsaber.
Now my main problem is I need a small enough toggle switch that will sit flush into this piece here...
http://i3.photobucket.com/albums/y60/Bi ... C02277.jpg
Because this piece has to sit flush against the one I just posted..
http://i3.photobucket.com/albums/y60/Bi ... C02279.jpg
So does anyone know of any online shops or hobby stores that I can get small toggle switches from? Preferably places that are reliable. Oh and if the switches all ready have wires in installed onto em' that's a major plus... if not I can always solder them on myself...but any and all help will be appreciated from you folks!
P.S. Ignore the condition of those pieces that's my fault.
Where to get small switches?
Moderators: DasPhule, Moderators
-
Captain-Raveers
- Posts: 4002
- Joined: Fri Apr 11, 2003 5:37 am
- Location: Earth
-
Umi_Ryuzuki
- Posts: 3841
- Joined: Fri Jul 12, 2002 2:22 pm
- Location: PDX, Oregon
- Contact:
Check your local electronic store, or Radio shack for some simple slide switches. If you have to cut or file down the switch lever.
There are usually some pretty small ones available.
Unless I was building a custom sink pipe saber, I typically reused the switches that were originally installed in the MR sabers.
Boat switches,... sabres are in there somewhere also...
There are usually some pretty small ones available.
Unless I was building a custom sink pipe saber, I typically reused the switches that were originally installed in the MR sabers.
Boat switches,... sabres are in there somewhere also...
-
Captain-Raveers
- Posts: 4002
- Joined: Fri Apr 11, 2003 5:37 am
- Location: Earth
!!!
