Fiber optics flush with plastic, but need to have convex...

No_6 · Post by **No_6** » Sat Mar 14, 2009 12:19 am

I made a mistake with my painting/fiber optics. During the painting I wound up cutting all the fiber optics flush with the surface (they're fixed inside with epoxy), but I wanted the ends to be convex, bulging out. Is there something I can use to create this effect?

robiwon · Post by **robiwon** » Sat Mar 14, 2009 7:08 am

Use a needle or a sharp toothpick, etc. to put a drop of either Micro Krystal Klear or a drop of clear Tamiya acrylic on each FO.

No_6 · Post by **No_6** » Mon Mar 16, 2009 4:41 am

Thanks! I'll give that a shot.