Filling model rocket cardboard tube spirals
Moderators: DasPhule, Moderators
Filling model rocket cardboard tube spirals
What can I fill the spiral seams of a wound cardboard tube like those of model rockets? I doubt I can slap on putty as usual with plastic then sand under running water till smooth.
-
bigbluejavelin
- Posts: 277
- Joined: Thu Jul 30, 2009 7:57 pm
- Location: Akron, Ohio
Re: Filling model rocket cardboard tube spirals
It's been decades Since I did a rocket, but I would suggest sanding sealer applied with a brush in the groove and light sanding.
Too much LDS
Re: Filling model rocket cardboard tube spirals
Rough tube like shipping tube/paper towel roll or glassine coated as in a regular rocket B/T?
Last edited by widget on Sun May 05, 2019 7:41 am, edited 1 time in total.
This IS my sig.
Re: Filling model rocket cardboard tube spirals
It's the rocket body tubes in the new (reissued) Estes Saturn V kit. I haven't tried sanding sealer in years. I was thinking white glue but that might not be smooth and it wouldn't sand. Not being one to wait, I've already given the service module enough coats of silver to mostly fill in the seams on it. But that doesn't seem like a solution for the large Saturn stages.
