3d Printed Model Painting Prep?

Got a question about techniques, materials or other aspects of physically building a model? This is the place to ask.

Moderators: DasPhule, Moderators

Post Reply
User avatar
Tchail
Posts: 4331
Joined: Tue Mar 04, 2003 8:40 pm
Location: Nowhere in Particular

3d Printed Model Painting Prep?

Post by Tchail »

I bought a 3d printed model of the Discovery One, from 2001.

Is there anything I need to do to prep the model for painting?

(E.g., washing the model with either Ajax or dish soap?)

Any suggestions would be appreciated!
“In the beginning the universe was created. This made a lot of people angry, and has generally been regarded as a bad move." Episode 5, The Hitchhiker's Guide to the Galaxy
DonS
Posts: 167
Joined: Fri Feb 05, 2010 3:17 pm

Post by DonS »

I use water and Dawn dish soap. No problems so far when priming with Tamiya fine primer.
See here for 1/48 scale SHADO Sky 1 info: http://www.donshoko.com

Or visit my CG gallery: http://www.eclectric-fx.com
User avatar
SCI-FI
Posts: 943
Joined: Sun Aug 23, 2009 9:14 pm
Location: Isengard

Post by SCI-FI »

Please keep us updated, re tools and process. I have a few Shapeways prints that I'll be painting in the near term...
User avatar
Squall67584
Posts: 905
Joined: Wed Nov 12, 2008 7:32 pm
Location: Just south of Houston

Post by Squall67584 »

I've had a few parts printed in fine ultra detail, and they have a waxy coating. I cleaned them with hot water and isopropyl alcohol, then put them in a Sonic cleaner with hot water and dawn.

The grow lines were obvious, so I sanded against the grain with wet 1000 grit and that made the parts smooth.
"I never wanted to be anything else but an Engineer." - Montgomery Scott

My Star Wars "fanfic" story series. Sequel in Progress!
Remnants of the Force

Way of the Blaster
DeltaVee
Posts: 2931
Joined: Wed Oct 01, 2003 9:34 am

Post by DeltaVee »

Gunze Mr. Resin Primer 500 works nicely. Sanding that nylon is like sanding rubber.
Post Reply